Book a session
Home / Subjects / Physics / GCSE / IGCSE Physics / Electrical Power and Mains Electricity
Electricity

Electrical Power and Mains Electricity

Power and energy in circuits, the cost of electricity, mains safety, fuses and the national grid.

The big idea

Every appliance transfers energy at a certain rate, its power. Mains electricity is an alternating supply (about 230 V, 50 Hz in the UK and UAE). Fuses, earth wires and circuit breakers protect people and appliances when something goes wrong.

earth (green and yellow)neutral (blue)live (brown)fuse
Inside a three-pin plug. The fuse is in the live wire, so it disconnects the supply if the current gets too high.

Key ideas

  • Power = current × voltage. Energy transferred = power × time.
  • Electricity bills use the kilowatt-hour: the energy a 1 kW appliance transfers in 1 hour.
  • Live wire (brown) carries the alternating voltage, neutral (blue) completes the circuit, earth (green and yellow) is for safety.
  • A fuse melts if the current is too high. Choose the rating just above the normal working current.
  • The national grid transmits at very high voltage and low current to cut the energy wasted heating the cables.

Equations

P = IVpower
P = I²Rpower lost in a resistance
E = Ptenergy
E = QVenergy and charge

Worked example

A 2300 W kettle works on 230 V. Find its current, a suitable fuse (3 A, 5 A or 13 A), and the energy it uses in 3.0 minutes in joules and in kWh.

  1. I = P/V = 2300/230 = 10 A, so use the 13 A fuse.
  2. E = Pt = 2300 × 180 = 414 000 J.
  3. In kWh: 2.3 kW × 0.050 h = 0.115 kWh.
Answer: 10 A; 13 A fuse; 414 kJ = 0.115 kWh

Common mistakes

  • Putting time in minutes into E = Pt when you want joules.
  • Saying a fuse protects the user from shocks. It protects the wiring from overheating; the earth wire and breakers protect people.

Try it yourself

A 60 W lamp is on for 5 hours. How many kWh does it use?

Show the answer

0.060 kW × 5 h = 0.30 kWh.

GCSE exam level

Going deeper: GCSE exam level

Exam technique, a longer multi-step worked example and exam-style practice with hidden solutions.

Why the grid uses high voltage

The power wasted in a cable is I²R. For the same power delivered, a higher voltage means a smaller current, and halving the current cuts the waste to a quarter. Step-up transformers raise the voltage at the power station, and step-down transformers lower it again near homes. Alternating current keeps changing direction; direct current from a battery flows one way only.

More worked examples

Example 1. A power station sends 2000 kW along cables with a total resistance of 5.0 Ω. Compare the power wasted at 10 kV and at 400 kV.

  1. At 10 kV: I = P/V = 2 000 000/10 000 = 200 A.
  2. Wasted = I²R = 200² × 5.0 = 200 kW, which is 10% of the power.
  3. At 400 kV: I = 2 000 000/400 000 = 5.0 A.
  4. Wasted = 5.0² × 5.0 = 125 W, almost nothing.
Answer: 200 kW at 10 kV; 125 W at 400 kV

Exam-style practice

1. Choose a fuse (3 A, 5 A or 13 A) for a 3 kW heater on 230 V.

Show the solution

I = 3000/230 = 13.0 A, so the 13 A fuse.

2. A 2 kW heater runs for 3 hours. Electricity costs 0.30 per kWh. Find the cost.

Show the solution

2 × 3 = 6 kWh; 6 × 0.30 = 1.80.

Where this fits in each exam board

Cambridge IGCSE (0625)Topic 4: Electricity and magnetism
Edexcel International GCSE (4PH1)Section 2: Electricity
AQA GCSE (8463)4.2 Electricity
Worksheet for this lesson

4 questions to print or save, with full step-by-step answers at the end.

See it in action

Open the Resistor Network Simplifier simulation and test every idea on this page yourself.

Open the simulation →